CORE Support Portal

The front lines of a bar are subjected to higher loads, so they may stretch usually over time. It is possible to stretch the lines unequally by practicing f...

The transparent version of the Rotor was our first version of the new design and was sold until summer of 2012. The massive yellow Rotor replaced it.  W...

You replace the Sensor depower line and you find it longer than the older version. This is because the attachment point to the massive yellow Rotor 1.1 (not...

Short answer: No The lines are made of a high strength Dyneema line, which has a breaking load of 780kg (!). We splice a pigtail to each end. See a simp...

Sensor 2 Bar The leash ring should be fed through the safety line first. Then push the stopper on and make a figure eight knot. Pull the stopper ball/cover...

Short answer: Yes You should try to fix it immediately, because a front line can lose 30% of its strength with an overhand knot in it. You have to softe...

Short answer: Yes The Core Sensor Bar  is delivered in the default setting over the sail cloth covered line. The clam cleat may be moved closer but no m...

Disclaimer: CORE Kiteboarding GmbH assumes no liability for damage or injury caused due to an incorrectly trimmed non CORE kite and not complying with the s...

In the following video we show you how to change the loop on a 5th HD or ESP Bar. If the pin is sticky and difficult to remove, apply a few drops ...

The rubberline is pulled through the QR like shown on the picture. Pull both ends through the chickenstick (less wider end of the stick to the QR) and hold ...